Worx WX540.3 Manual de Serviço descarregar pdf (Página 22)

12V Li-Ion multi-purposed saw EN

2322

5. CUTTING

WARNING: Always wear eye protection

while operating this power tool.

WARNING:

• Never hold the pivot head when operating

the tool.

• Never hold the motor cover when

operating the tool.

Before cutting any type of material, be sure

it is ﬁrmly anchored or clamped to prevent

slipping. Holding the work by hand or

against your body leaves it unstable and

may lead to loss of control.

• Place blade lightly against work to be cut,

depress the trigger switch and allow it to

obtain maximum speed before applying

pressure.

• Whenever possible, the saw foot plate

must be held ﬁrmly against the material

being cut. This will prevent the saw from

jumping or vibrating and minimize blade

breakage.

• Any cut which puts pressure on the blade,

such as angle or scroll cuts, increases

potential for vibration, kickback and blade

breakage.

WARNING: Shock hazard. Use extra

caution when cutting overhead and pay

particular attention to overhead wires which

may be hidden from view.

WARNING: Use extra caution when

cutting overhead and anticipate the path

of falling branches and debris ahead of time.

WARNING: Inspect work site for hidden

gas pipes, water pipes, or electrical

wires before making blind or plunge cuts.

Failure to do so may result in explosion,

property damage, electric shock, and/or

serious personal injury.

WORKING HINTS FOR YOUR

MULTI-PURPOSED SAW

If your power tool becomes too hot, set the

speed to maximum and run no-load for 2-3

minutes to cool the motor. Avoid prolonged

usage at very low speeds.

GENERAL

Always use a blade suited to the material and

material thickness to be cut.

Always ensure the work–piece is ﬁrmly held or

clamped to prevent movement.

Any movement of the material may affect

the quality of the cut. The blade cuts on the

upward stroke and may chip the uppermost

surface.

Ensure your uppermost surface is a non-

visible surface when your work is ﬁnished.

MAINTENANCE

Your power tool requires no additional

lubrication or maintenance.

There are no user serviceable parts in your

power tool. Never use water or chemical

cleaners to clean your power tool. Wipe clean

with a dry cloth. Always store your power tool

in a dry place. Keep the motor ventilation slots

clean. Keep all working controls free of dust.

Occasionally you may see sparks through the

ventilation slots. This is normal and will not

damage your power tool.

TROUBLESHOOTING

Symptom

Possible

Causes

Possible

Solution

The tool

suddenly

stops during

operation.

Over load

Battery tem-

perature too

high

Low battery

capacity

Relieve the

load on the

machine

immediately

and allow

cooling for

approx. 30

seconds by

running the

machine on

on-load .

Charge the

battery pack.

1 2 ... 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários